Freecad

0.18

Adding Engraved Text to Shape

This is tricky. It seems that it always is.

Make sure to extrude the text before adjusting x,y,z on the 3d plane. Otherwise the extrusion will be offset by the earlier placement.

See freecad wiki tutorial. you can skip the sketcher part.

Some guides say to use shapestring to trimex. That didn't work for me. Trimex would fail.

However, shapestring, to then PART workbench (not part design)(its bad design they are named similarly is it not? Endlessly confusing.), To then part extrude worked.

Ugh. 30 minutes of my life